Wynnum Plumber

TRUSTED SOURCES WE USE

Frequently Asked Questions

Will bleach unclog a toilet?

Bleach does not harm toilets. It just makes them clean. If you are worried about clogged drains, use an alternative method, such as baking soda (sodium bicarbonate). Baking soda dissolves solid material and helps to clear up blockages. You can also add some vinegar to help dissolve hardened deposits. However, these methods should never be used near sinks, tubs, or showers. These chemicals can damage fixtures and cause damage to surfaces.

How do you unclog a toilet with standing water?

You pour boiling water into the bowl until the water level rises above the trap door. The trapped air bubbles expand, forcing the blockage back toward the drain. Once the blockage reaches the drain opening, it will break free.

However, this method may not work well if there's already a lot of debris in the toilet bowl. The trapped air bubbles may force the obstruction further into the bowl and create more mess. Try pouring boiling water directly into the toilet bowl to avoid this problem.

How do I clear my main drain line?

You should first check if you have an old toilet tank installed and remove it. If you don't know how to remove a toilet tank, please contact us for help.

Next, you have to turn off the power supply to your house. Turn off the breaker box and disconnect the wires from the circuit breaker. Next, open the lid of the main drain and pour hot water into it until it clears the drain line.

After the water has cleared the drain line, close the lid of the main drainage and reconnect the electricity. Wait for 30 minutes, then run cold water through the drain for 10-15 minutes. The drain line should now be cleared.

What can you put in a toilet to dissolve a clog?

Clogs happen when water stagnates for too long. So, how do we make sure that doesn't happen? We flush it out!

Flushing water is nature's way of clearing things out, so flushing toilets is an effective way to eliminate blockages.

There are two main types of flushes. A complete flush uses more water than a half-flush but removes more material. If you have a slow leak, a half-flush may be sufficient. But if a lot of debris is stuck in the drain, a full flush might help.

You probably already know that you should keep the lid closed while flushing. This prevents water from splashing back onto the floor. However, if you leave the door open, you could let in some air that would cause the waste to rot faster.

The best time to clean the drains is after each shower. When you turn on the tap, the pressure pushes all the water through the pipes. This helps dislodge any bits of hair or soap that are stuck inside.

If you find yourself with a clogged drain, don't panic. There are ways to unclog it without calling a plumber. For example, you can pour boiling hot water down the pipe. Or, you can run vinegar down the sink. Vinegar is acidic. As such, it reacts with the minerals in the pipes and dissolves them.

It's important to note that these methods aren't safe for children or pets. In addition, they won't remove the clog if it's caused by grease or food particles.

Statistics

It adds up to 50 percent more solids to your septic tank, and your tank will require more frequent pump-outs. (scdhec.gov)
Washing machines that bear this label perform with an energy savings of 35 percent and a water savings of 50 percent over regular models. (mrrooter.com)
Toilet use accounts for 25 to 30 percent of household water use. (epa.gov)
For about 90 percent of clogged toilets, you only need one special tool — a toilet plunger. (familyhandyman.com)
Your tank should be pumped if the bottom of the scum layer is within six inches of the bottom of the outlet, if the top of the sludge layer is within 12 inches of the outlet, or if more than 25% of the liquid depth is sludge and scum. (epa.gov)

External Links

How To

How To Unclog A Drain without Chemicals

If you're looking for ways to unblock your drains, here's some great advice from our friends at Home Improvement Store.

The first thing to do if you suspect there might be a blockage in your drain is to turn off the water supply. This should stop any further flow into the pipe, which could cause damage to your home and property. If this doesn't work, try pouring hot water down the sink or bathtub to see if you can clear the blockage.

You can also use a plunger to push the obstruction out of the drainpipe. However, ensure that you don't force anything through the pipe, as this could be dangerous.

Finally, if none of these methods work, you'll need to call a professional plumber. They'll be able to remove the problem quickly and efficiently.

Don't forget to check the area outside your house too. You may find that a tree branch or something else has fallen into the pipes and blocked them.